nsanu.blogg.se - Amd nvme driver download

This is the second minor problem with the instructions: Windows now says "Select the driver to install" and shows TWO IDENTICAL LINES:ĪMD-RAID Bottom Device (D:\WIN10\圆4\NVMe_CC\rcbottom\rcbottom.inf") , down to WIN10/圆4/NVMe_CC/rcbottom and click OK. This is where the first problem with the instructions shows up: Which drivers? NVMe_CC or NVMNe_ I click Browse and go to the USB drive with the AMD RAID drivers. It says "No signed device drivers were found. This is expected since I haven't loaded the drivers yet. So Windows sees the raw disks, not the RAID.

Drive 1 Partition 1 931.5 GB 0.0 MB free, Primary.

Drive 0 Partition 1 931.5 GB, 0.0 MB free, Primary.

It asks: Where do you want to install Windows? I enter the Windows registration key, accept license terms, and choose "Custom: Install Windows only", not Upgrade. I have also installed the AMD RAID drivers referred to above on a second USB. My license key is for Windows 10 Professional. I created this USB yesterday using the Microsoft MediaCreationTool20H2.exe.

I save changes & exit from the BIOS, and boot Windows from USB. If I dig down to look at the physical disk properties they look correct, Used Space is the full 1.0 TB, they are both associated with the array and not hot spares. Physical Disk 1:1:0, NVMe Gen4 x4, 1.0 TB, Online.Physical Disk 0:1:0 NVMe Gen4 x4, 1.0 TB, Online.Viewing the Associated Physical Disks, it shows The Array Properties also mention the Cache Tag Size of 256KB, "No Cache" for both Read Cache Policy and Write Cache Policy. Under Array Management, Manage Array Properties it shows one array, "Array 1, RAID0, 1.9 TB, Normal".and the last two controllers have no disks. Controller 1 is the same, one controller disk, 2 total physical disk, etc. It shows Controller Physical Disk Count: 1, Total Physical Disk Count: 2, Array Count: 1, UEFI Driver Version 9.2.0-00127, Firmware Build Time 13:37:01.I'm looking at Controller 0:AMD-RAID 00:01:00:00 VID 0x44D DID 0xA80A Controller Information has a lot of details.In the Advanced\RAIDXpert2 Configuration Utility: Under "Advanced\AMD CBS" everything is set to defaults, mostly "Auto". NVMe RAID mode is Enabled under "Advanced\AMD PBS"

The "Storage Device(s) List" there is blank. In the BIOS under "Boot", CSM is DisabledīIOS "Storage Configuration" has SATA controllers in RAID mode, but I don't have any SATA devices. Bios says it's currently running 8 cores at 3651 Mhz, 38C/100F Ryzen 7 3700X, no overclock, all the bios settings at "Auto".Two Samsung 1 TB 980PRO PCIe 4.0 NVMe M.2 drives.2 x 32 GB G.Skill RAM, using detected XMP 2.0 profile, DDR4-3600 16-22-22-42 1.45V which exactly matches the RAM specs.Asrock x570 Taichi with Bios updated to 3.80.All of this is brand new out of the box yesterday.